1 Oil the contact areas on the shaft, adapter sleeve and bearing only very thinly prior to mounting.

2 Place the bearing onto the tapered surface.

3 Screw the sleeve nut onto the adapter sleeve.

4 Drive the bearing further up the tapered surface by light tightening the nut (as shown the angle "p")with a hook wrench. This light tightening procedure will make sure thatthere is not any clearance between adapter sleevebore and the shaft.

5 Further tighten the lock nut with angle "A" in the table ( page 11) is recommended.

6 Alternatively, the displacement specifie in the table may be measured using a depth micrometer,slide caliper or dial gauge.

7 Secure the adapter sleeve nut.